Microfluidic device manufacturing with laser

mems polymer replication on nanoscale

Aachen, Germany – Technologist René Sanders gave a presentation about the manufacturing of shims for microfluidics (µF) on May 8–9, 2017, during the 4th International Conference on Polymer Replication on Nanoscale (PRN 2017).

Microfluidic devices manufacturing

Microfluidic devices like barriers, channels, jets, meshes, nozzles, and complete functional chips, can be manufactured in silicon, glass, polymers or metal. At the Philips Innovation Services MEMS foundry, microfluidic devices are manufactured with MEMS & thin film process steps: lithography, nano-imprint, dry and wet etching and deposition, and using a variety of laser systems. The flexibility of a laser allows for fast prototyping of precise structures, enabling short iteration loops to speed up microfluidic device development.

Microfluidic device standardization project

The presentation from René Sanders dives into the ENIAC MFManufacturing project, a European initiative for the standardization and manufacturability of complex microfluidic devices. The goal of this project is to bring microfluidic devices manufacturing to the same maturity and industrialization level as electronic devices, a requirement for successful integration into the MEMS production process.

Manufacturing of shims for micro-fluidics presentation by René Sanders, Technologist at Philips Innovation Services

The laser part of this project focusses on standardization to 15 x 15 x 1 mm³ units with fixed in- and outlet dimensions and positions. The European project ENIAC made it possible to demonstrate the feasibility of microfluidic device manufacturing, using laser in combination with injection molding.

As demonstrators, two basic µF building blocks were made: a µF mixing channel and µF capillary pumps. Partners within the ENIAC project have conducted functional tests of the µF mixing channel and µF capillary pumps. Conclusions from the functional tests of the µF mixing channel and µF capillary pumps:

  • Mixer: channel filled with small ribs enhances mixing
  • Capillary pump: array of pillars increases capillary force

Using the laser method in the microfluidic device manufacturing process

The basic process flow for microfluidic device manufacturing using the laser-polymer-molding-method was tested:

  1. Laser ablation of µF structures
  2. Polycarbonate master
  3. Nickel shim
  4. Injection molded COP (cyclo olefin polymer) part
  5. Dicing into individual parts

Working with laser allows for precise structures while simultaneously allowing flexibility in the development process with rapid iterations and variations. Once a good design is established experimentally, the polymer structures are electroplated and serve as a shim for injection molding, transitioning from single piece prototyping to mid and high volume production.

Advantages of the laser method

Laser has the limitation that only polycarbonate can be used. However, through the injection molding route, a large number of polymers can be formed, such as COP, COC, PMMA, and of course PC. The laser method is capable of making structures that are impossible or difficult to create using conventional methods (e.g. milling). See as an example the pile structures in the presentation.

More information on microfluidic devices & prototyping:

 

rene sanders

René Sanders

Technologist, device assembly prototyping

Presentation microfluidic device manufacturing with laser PDF

Contact us

 

Share on:

Philips respects your privacy. We use cookies for a variety of purposes, such as website functionality, improving your experience of our website, building integration with social media and helping target our advertising. More information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close